LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Engine Mechanical - 3.1L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Camshaft Rear Bearing Hole Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Coat the camshaft rear bearing hole plug with sealer. Use sealer GM P/N 12377901 (Canadian P/N 10953504) or the equivalent.
  2. Install the camshaft rear bearing hole plug.
    Fig 1: Installing Camshaft Rear Bearing Hole Plug
    G02081504Courtesy of GENERAL MOTORS CORP.
  3. Ensure that the camshaft rear bearing plug is installed to specifications.
  4. Install the engine flywheel. Refer to ENGINE FLYWHEEL REPLACEMENT  .
    Fig 2: Installing Engine Flywheel
    G02081505Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals