LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 708 (Engine Mechanical - 3.1L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Valve Rocker Arm Cover Installation - Left

Valve Rocker Arm Cover Installation - Left

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the valve rocker arm cover gasket into the valve rocker arm cover.
  2. Apply sealer GM P/N 12346286 (Canadian P/N 10953472) or the equivalent to the notches where the cylinder head and intake manifold meet.
  3. Install the valve rocker arm cover.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the valve rocker arm cover bolts.

    Tighten 

    Tighten the valve rocker arm cover bolts to 10 N.m (89 lb in).

    Fig 1: Installing Left Valve Rocker Arm Cover
    G02081740Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals