LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 698 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Heater Pipe Adapter Replacement - Inlet (3.8L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the O-ring with coolant.
  2. Install the heater pipe adapter
    NOTE: Refer to FASTENER NOTICE .
  3. Install the heater pipe adapter mounting bolt.

    Tighten 

    Tighten the bolt to 6 N.m (53 lb in).

    Fig 1: Installing Heater Pipe Adapter & Mounting Bolt
    G01482088Courtesy of GENERAL MOTORS CORP.
  4. Connect the heater inlet hose to the pipe adapter.
  5. Use J 38185  in order to secure the heater core hose clamp.
  6. Install the fuel injector sight shield. Refer to FUEL INJECTOR SIGHT SHIELD REPLACEMENT (L36) or FUEL INJECTOR SIGHT SHIELD REPLACEMENT (L67) .
  7. Refill the cooling system. Refer to DRAINING AND FILLING COOLING SYSTEM .
Fig 2: View Of Heater Pipes
G01482089Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals