LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 698 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Compressor Clutch Coil Removal (V5 - Direct Mount) >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the compressor onto the J41790.
    Fig 1: Installing Compressor Onto Compressor Holding Fixture (V5 - Direct Mount)
    G01481909Courtesy of GENERAL MOTORS CORP.
  2. Install the J 33023-A  onto the front head of the compressor.
  3. Remove the compressor clutch plate and hub assembly. Refer to Compressor Clutch Plate And Hub Assembly Removal (V5 - Direct Mount)   or  Compressor Clutch Plate And Hub Assembly Removal (V5 - Conventional Mount)   . 
  4. Remove the compressor rotor and bearing assembly. Refer to Clutch Rotor And/Or Bearing Removal (V5 - Direct Mount)   or  Clutch Rotor And/Or Bearing Removal (V5 - Conventional Mount)   . 
    Fig 2: Installing Puller Pilot Onto Front Head Of Compressor (V5 - Direct Mount)
    G01481910Courtesy of GENERAL MOTORS CORP.
  5. Mark the clutch coil terminal location (2) on the compressor front head.
  6. Install the J 33025  onto the J 8433  .
  7. Install the J 8433  onto the compressor clutch coil (1) and tighten the puller leg bolts.
  8. Tighten the center forcing screw J 8433-3  of the compressor pulley puller J 8433  against the puller pilot to remove the compressor clutch coil from the compressor.
Fig 3: Compressor Clutch Coil Terminal Location (V5 - Direct Mount)
G01481911Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals