LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 694 (Steering Wheel And Steering Column) >> Repair Instructions >> Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle

Turn Signal and Multifunction Switch Assembly - Disassemble - Off Vehicle

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to SIR CAUTION .
  1. Disable the inflatable restraint steering wheel module. Refer to DISABLING SYSTEM .
  2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle .
  3. Remove the wire harness assembly (1) from the wire harness strap (2).

    Remove the wire harness straps from the wire harness assembly (1) and the steering column.

  4. Disconnect the turn signal and multifunction switch assembly connector from the inflatable restraint steering wheel module coil connector.
    Fig 1: Removing Wire Harness Assembly
    G01673171Courtesy of GENERAL MOTORS CORP.
  5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).
    Fig 2: Sliding Turn Signal & Multifunction Switch Assembly Out Of Bulkhead Connector
    G01673172Courtesy of GENERAL MOTORS CORP.
  6. Remove the 2 pan head tapping screws (1) from the turn signal and multifunction switch assembly (2).
  7. Remove the turn signal and multifunction switch assembly (2) from the steering column tilt head assembly.
    Fig 3: Removing Turn Signal & Multifunction Switch Assembly
    G01673173Courtesy of GENERAL MOTORS CORP.