LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 689 (Wiring Systems (General Information)) >> Repair Instructions >> Relay Replacement (Attached to Wire Harness) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate the relay.
  2. Remove any fasteners which hold the relay in place
  3. Remove the any connector position assurance (CPA) devices or secondary locks
    IMPORTANT: Use care when removing a relay in a wiring harness when the relay is secured by fasteners or tape
  4. Separate the relay (1) from the wire harness connector (2)
    Fig 1: Relay & Wire Harness Connector
    G01615917Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals