LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 684 (Power Steering System) >> Repair Instructions >> Power Steering Reservoir Replacement - Off Vehicle (CB Series) >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the hydraulic pump (1) on a fixed, flat surface, with the shaft facing upward.
  2. Insert a screwdriver into the retaining clip tab (3).
  3. Using the screwdriver, force the retaining clip tab (3) outward.
  4. Slide the reservoir clip (4) away from the hydraulic pump assembly (1).
  5. Repeat the above steps to remove the second reservoir clip (4).
  6. Remove the reservoir (2) from the hydraulic pump housing (1).
  7. Remove the O-ring seal from the neck of the reservoir (2) or the hydraulic pump housing (1).

    Discard the O-ring seal.

    Fig 1: Removing Reservoir Retaining Clips
    G01672997Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals