LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Right Front (Convertible) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Uncover the upper guide nut by pushing up at the belt edge of the cover and flipping up the cover.
  2. Remove the nut attaching upper guide.
  3. Remove the washer and spacer from the stud.
    Fig 1: Removing Nut Attaching Upper Guide
    G01452374Courtesy of GENERAL MOTORS CORP.
  4. Remove the screw attaching the upper lock pillar trim panel.
  5. Remove the upper lock pillar trim panel.
    Fig 2: Removing Upper Lock Pillar Trim Panel
    G01452375Courtesy of GENERAL MOTORS CORP.
  6. Remove the sill plate trim.
  7. Remove the lower lock pillar trim panel.
    Fig 3: Removing Lower Lock Pillar Trim Panel
    G01452376Courtesy of GENERAL MOTORS CORP.
  8. Remove the bolt attaching the upper retractor.
  9. Remove the bolt attaching the lower retractor.
  10. Remove the retractor side of the seat belt.
    Fig 4: Removing Retractor Side Of Seat Belt
    G01452377Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals