Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the upper retractor and attaching bolt.
Tighten

Tighten the upper retractor bolt to 41 N.m (30 lb ft).
Install the lower retractor and attaching bolt.
Tighten

Tighten the lower retractor bolt to 41 N.m (30 lb ft).

Fig 1: Installing Upper/Lower Retractor & Attaching Bolt
Courtesy of GENERAL MOTORS CORP.
Install the lower lock pillar trim panel.
Install the sill plate.

Fig 2: Installing Lower Lock Pillar Trim Panel
Courtesy of GENERAL MOTORS CORP.
Install the upper lock pillar trim panel.
Install the screw securing the upper trim panel.
Tighten

Tighten the upper lock pillar trim panel screw to 1.8 N.m (16 lb in).
Install the spacer and washer to the seat belt harness bracket stud.

Fig 3: Installing Upper Lock Pillar Trim Panel
Courtesy of GENERAL MOTORS CORP.
Install the upper guide to the stud.
Install the nut attaching the upper guide to the bracket stud.
Tighten

Tighten upper guide nut to 40 N.m (29 lb ft).

Fig 4: Installing Nut Attaching Upper Guide To Bracket Stud
Courtesy of GENERAL MOTORS CORP.
Snap the guide cover closed.