LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 681 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the valve to the opening with the cloth flaps hanging down.
  2. Snap the valve to the rear panel.

    Push firmly at each of the four snap locations.

  3. Install the rear corner carpet panel.
    Fig 1: Pressure Relief Valve
    G01452144Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals