LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 680 (Interior Trim) >> Repair Instructions >> Trim Panel Carpet - Rear Compartment Rear Center (Hardtop) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear compartment rear trim panel to the studs on the rear body panel.
  2. Route the manual release cable down behind the carpet trim panel and out through the slit in the trim panel into the floor stowage area.
  3. Tuck the trim panel upper flange under the rim of the rear panel.
  4. Install the convenience net installation nuts.
    Fig 1: Rear Trim Panel
    G01451842Courtesy of GENERAL MOTORS CORP.
  5. Install the cargo lamps.
  6. Tuck the rear trim behind the sides of the floor carpet.
    Fig 2: Cargo Courtesy Lamps
    G01451843Courtesy of GENERAL MOTORS CORP.
  7. Install the floor center stowage cover.
    Fig 3: Floor Center Stowage Cover
    G01451844Courtesy of GENERAL MOTORS CORP.