LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Seat System) >> Repair Instructions >> Seat Back Cover and Pad Replacement - Front (RPO AR9 Base Seat) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat forward.
  2. Tilt the seat back forward.
  3. Unzip the seat back cover.
  4. Unhook the seat back cover lower J strips by sliding the cover sideways.
  5. Carefully slide and pull the cover material out from under the seat back release lever bezel.
  6. Remove the cover unhooking the hook and loop fasteners from the foam pad.
  7. Remove the upper fasteners attaching the foam pad (if removing the pad).
  8. Remove the foam pad (if necessary).
    Fig 1: Foam Pad
    G01451677Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals