LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 678 (Folding Top System) >> Repair Instructions >> Weatherstrip Replacement - Folding Top (Rear Side Rail) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply a bead of sealer GM P/N 12345739 (Canadian P/N 10953472), to the upper and lower corners of the weatherstrip retainer.
    Fig 1: Applying A Bead Of Sealer To Upper & Lower Corners Of Weatherstrip Retainer
    G01451377Courtesy of GENERAL MOTORS CORP.
  2. Remove the protective film from the adhesive on the back of the weatherstrip.
  3. Install the weatherstrip to the rear side rail retainer.
  4. Install the rear weatherstrip into the end of the center rail side weatherstrip.
  5. Install the push-in retainer to the bottom of the weatherstrip.
  6. Reposition the folding top to the original position.
    Fig 2: Push-In Retainer To Bottom Of Weatherstrip
    G01451378Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals