LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 671 (Horn System) >> Repair Instructions >> Horn Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the right front fascia lower closeout panel. Refer to CLOSE OUT PANEL - FRONT BUMPER FASCIA LOWER in Bumpers.
  2. Disconnect the horn assembly electrical connector.
    Fig 1: Disconnecting Horn Assembly Electrical Connector
    G01454062Courtesy of GENERAL MOTORS CORP.
  3. Remove the horn assembly bolt.
  4. Remove the horn assembly from the skid bar.
    Fig 2: Removing Horn Assembly From Skid Bar
    G01454063Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals