LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 669 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Defroster Grille Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Rotate to secure the sunload sensor to the defroster grille, if equipped.
    Fig 1: Securing Sunload Sensor To Defroster Grille
    G01453896Courtesy of GENERAL MOTORS CORP.
  2. Rotate to secure the DRL sensor to the defroster grille, if equipped.
  3. Position the tabs along the front edge of the defroster grille down into the slots in the upper trim pad.
  4. Lower the rear edge of the defroster grille into position, then CAREFULLY press the rear tabs into place.
    Fig 2: Securing DRL Sensor To Defroster Grille
    G01453897Courtesy of GENERAL MOTORS CORP.