Radio Theft-Deterrent Activating
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
The following instructions explain how to enter a secret code to activate the THEFTLOCK™ system. Read all nine steps before starting the procedure.
Important: If more than 15 SECONDS is allowed to elapse between any steps, the radio automatically reverts to displaying time and the procedure must be started over at Step 4.
- Write down any three or four-digit number from 000 to 1999. Keep the number in a safe place separate from the vehicle. This number is the secret code.
- Turn the ignition to the ACCESSORY or ON position.
- Turn the radio OFF.
- Press the number 1 and 4 push buttons at the same time. Hold the number 1 and 4 push buttons down until "- - -" appears on the VF display.
- Press MN. 000 will appear on the display.
- Press MN again until the last two digits agree with the last two digits of the secret code.
- Press HR until the first one or two digits agree with the first one or two digits of the secret code.
- Press AM/FM after confirming that the display code matches the secret code. REP appears on the display indicating that steps 5 through step 7 need to be repeated to confirm the secret code.
- Press AM/FM again. SEC appears on the display indicating that the radio is secure. The indicator light by the PWR-VOL control begins flashing when the ignition is turned off.