LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 664 (Lighting Systems) >> Repair Instructions >> Tail/Turn Signal Lamp Replacement (Europe, Japan) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulbs to the lamp sockets, if replacing the bulbs.
  2. Install the sockets to the lamp assembly.
  3. Position the tail/turn signal lamp assembly to the rear fascia.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the tail/turn signal lamp screws to the rear fascia.

    Tighten 

    Tighten the tail/turn signal lamp screws to 2 N.m (18 lb in).

    Fig 1: Installing Sockets To Lamp Assembly
    G01453411Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals