LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 664 (Lighting Systems) >> Repair Instructions >> Position Lamp Replacement - Front (Europe Japan) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the front position lamp to the front fascia.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the front position lamp retaining screw.

    Tighten 

    Tighten the front position lamp retaining screw to 2 N.m (18 lb in).

    Fig 1: Front Position Lamp Retaining Screw
    G01453361Courtesy of GENERAL MOTORS CORP.
  3. Install the socket to the lamp.
  4. Close the lamp access door on top of the front fascia closeout.
    Fig 2: Installing Socket To Lamp
    G01453362Courtesy of GENERAL MOTORS CORP.
  5. Position the brake caliper cooling duct to the front fascia and press to secure.
  6. Install the front fascia lower closeout panel. Refer to CLOSE OUT PANEL - FRONT BUMPER FASCIA LOWER in Bumpers.
  7. Lower the vehicle.
    Fig 3: Positioning Brake Caliper Cooling Duct To Front Fascia
    G01453363Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals