LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 664 (Lighting Systems) >> Repair Instructions >> Park/Turn Signal/Side Marker Lamp Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the front fascia lower closeout panel. Refer to CLOSE OUT PANEL - FRONT BUMPER FASCIA LOWER in Bumpers.
  3. Release the brake caliper cooling duct from the front fascia, and position the duct aside.
    Fig 1: Releasing Brake Caliper Cooling Duct From Front Fascia
    G01453376Courtesy of GENERAL MOTORS CORP.
  4. Remove the front turn signal lamp bracket retaining spring from the lamp bracket.
  5. Remove the lamp bracket retaining spring from the front fascia.
  6. Remove the front turn signal lamp bracket retaining screws.
    Fig 2: Removing Lamp Bracket Retaining Spring From Front Fascia
    G01453377Courtesy of GENERAL MOTORS CORP.
  7. Disconnect the sockets from the lamp.
    Fig 3: Disconnecting Sockets From Lamp
    G01453378Courtesy of GENERAL MOTORS CORP.
  8. Remove the lamp, with the bracket, from the vehicle.
  9. Remove the lamp to bracket retaining screws.
  10. Remove the lamp from the bracket.
    Fig 4: Removing Lamp To Bracket Retaining Screws
    G01453379Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals