LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 662 (Manual Transmission Clutches) >> Repair Instructions >> Release Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driveline support assembly and the transaxle from the vehicle (with the clutch actuator cylinder). Refer to DRIVELINE SUPPORT ASSEMBLY REPLACEMENT (AUTOMATIC TRANSMISSION) or DRIVELINE SUPPORT ASSEMBLY REPLACEMENT (MANUAL TRANSMISSION) in Propeller Shaft.
  2. Remove the clutch release bearing.

    Rotate the bearing in either direction.

    The compression spring load will push the release bearing off the end of the clutch actuator cylinder.

    Fig 1: Clutch Release Bearing
    G01973185Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals