LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 662 (Manual Transmission Clutches) >> Repair Instructions >> Clutch Pedal Position Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION in Cautions and Notices.
  1. Disconnect the negative battery cable.
  2. Remove the clutch master cylinder reservoir cap (clutch start switch) electrical connector.
    Fig 1: Clutch Master Cylinder Reservoir Cap
    G01973174Courtesy of GENERAL MOTORS CORP.
  3. Insert a feeler gauge between the switch and the clutch pedal bracket to release the switch tab.
  4. Remove the switch.

    Lift the switch slightly then pull to remove.

    Fig 2: Clutch Pedal Position Switch
    G01973175Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals