Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Using the J 41099 , install the gear select (skip shift) solenoid.
Tighten

Tighten the gear select solenoid to 40 N.m (30 lb ft).

Fig 1: Using J 41099 To Install Gear Select (Skip Shift) Solenoid
Courtesy of GENERAL MOTORS CORP.
Connect the gear select solenoid electrical connector.
Lower the vehicle.

Fig 2: Connecting Gear Select Solenoid Electrical Connector
Courtesy of GENERAL MOTORS CORP.