LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 659 (Manual Transmission - Mm6/M12) >> Diagnostic Information and Procedures >> DTC P0803: Internal Fault Detection Circuit >> Test Description

Test Description

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 2. Listen for an audible click when the reverse inhibit solenoid operates. Command both the ON and OFF states. Repeat the commands as necessary.
  2. 3. Tests for voltage at the coil side of the reverse inhibit solenoid. The ENG IGN 1 fuse supplies power to the coil side of the reverse inhibit solenoid.
  3. 5. Verifies that the powertrain control module (PCM) is providing ground to the reverse inhibit solenoid.
  4. 6. Tests if ground is constantly being applied to the reverse inhibit solenoid.
    Fig 1: DTC P0803 (1 Of 2)
    G01971282Courtesy of GENERAL MOTORS CORP.
    Fig 2: DTC P0803 (2 Of 2)
    G01971283Courtesy of GENERAL MOTORS CORP.