LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 655 (Engine Mechanical - 5.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Oil Level Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the oil pan drain plug.
  3. Completely drain the engine oil.
  4. Disconnect the engine oil level sensor electrical connector.
  5. Remove the engine oil level sensor.
    Fig 1: Removing Engine Oil Level Sensor
    G01970600Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals