LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 655 (Engine Mechanical - 5.7L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Drive Belt Idler Pulley Replacement-Air Conditioning >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the idler pulley bolt.
    Fig 1: Installing Air Conditioning Drive Belt Idler Pulley
    G01970360Courtesy of GENERAL MOTORS CORP.
  2. Install the A/C drive belt idler pulley bolt until snug.

    Important:  Ensure that the idler pulley is fully seated against the shoulder on the bracket before tightening the bolt.

  3. Install the A/C drive belt. Refer to DRIVE BELT REPLACEMENT-AIR CONDITIONING  .
    NOTE: Refer to FASTENER NOTICE .
  4. Tighten the A/C drive belt idler pulley bolt.

    Tighten 

    Tighten the A/C drive belt idler pulley bolt to 50 N.m (37 lb ft).

scientia non olet · About LEMON Manuals