Valve Rocker Arm Cover Removal - Right

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Important: Do not remove the oil fill tube from the cover unless service is required.

If the oil fill tube has been removed from the cover, install a NEW tube during assembly.

Remove the ignition coil and bracket assembly and bolts.

Fig 1: Removing Ignition Coil And Bracket Assembly
Courtesy of GENERAL MOTORS CORP.
Remove the valve rocker arm cover bolts.
Remove the valve rocker arm cover.

Fig 2: Removing Valve Rocker Arm Cover - Right
Courtesy of GENERAL MOTORS CORP.
Remove the oil fill cap from the oil fill tube.
Remove the oil fill tube, if required.
Discard the oil fill tube.

Fig 3: Removing Oil Fill Tube
Courtesy of GENERAL MOTORS CORP.
Remove the gasket (1) from the cover.
Discard the gasket.
The bolt grommets may be used again if not damaged.

Fig 4: Removing Gasket
Courtesy of GENERAL MOTORS CORP.
Remove the ignition coils, wire harness, and bolts from the bracket, if required.

Fig 5: Removing Ignition Coils, Wire Harness, And Bolts
Courtesy of GENERAL MOTORS CORP.