LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 655 (Engine Mechanical - 5.7L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Valve Rocker Arm Cover Removal - Left

Valve Rocker Arm Cover Removal - Left

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Important:  Do not remove the positive crankcase ventilation (PCV) valve grommet from the cover unless service is required.

If the grommet has been removed from the cover, a NEW grommet must be installed.

  1. Remove the ignition coil and bracket assembly and bolts.
    Fig 1: Removing Ignition Coil And Bracket Assembly
    G01970760Courtesy of GENERAL MOTORS CORP.
  2. Remove the valve rocker arm cover bolts.
  3. Remove the valve rocker arm cover.
    Fig 2: Removing Valve Rocker Arm Cover - Left
    G01970761Courtesy of GENERAL MOTORS CORP.
  4. Remove the gasket (1) from the cover.
  5. Discard the gasket.

    The bolt grommets may be used again if not damaged.

    Fig 3: Removing Gasket
    G01970762Courtesy of GENERAL MOTORS CORP.
  6. Remove the ignition coils, wire harness, and bolts from the bracket, if required.
    Fig 4: Removing Ignition Coils, Wire Harness, And Bolts
    G01970763Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals