LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 655 (Engine Mechanical - 5.7L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Valley Cover Removal

Engine Valley Cover Removal

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the knock sensor wire harness.
    Fig 1: Removing Knock Sensor Wire Harness
    G01970755Courtesy of GENERAL MOTORS CORP.
  2. Remove the knock sensors.
    Fig 2: Removing Knock Sensors
    G01970756Courtesy of GENERAL MOTORS CORP.
  3. Remove the valley cover bolts.
  4. Remove the valley cover and gasket - LS1.
    Fig 3: Removing Engine Valley Cover & Gasket - LS1
    G01970757Courtesy of GENERAL MOTORS CORP.
  5. Remove the valley cover and gasket - LS6.
  6. Discard the valley cover gasket.
    Fig 4: Removing Engine Valley Cover & Gasket - LS6
    G01970758Courtesy of GENERAL MOTORS CORP.
  7. Remove the knock sensor oil seals (1) from the cover (2).
    Fig 5: Removing Knock Sensor Oil Seals
    G01970759Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals