LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 655 (Engine Mechanical - 5.7L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Head Removal - Right

Cylinder Head Removal - Right

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the spark plugs from the cylinder head.

    Important:  The cylinder head bolts can NOT be used again. Install NEW cylinder head bolts during assembly.

  2. Remove the cylinder head bolts.
    NOTE: After removal, place the cylinder head on two wood blocks to prevent damage.
  3. Remove the cylinder head.
    Fig 1: Removing Cylinder Head - Right
    G01970774Courtesy of GENERAL MOTORS CORP.
  4. Remove the gasket.
  5. Discard the gasket.
  6. Discard the cylinder head bolts.
    Fig 2: Removing Gasket
    G01970775Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals