LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 655 (Engine Mechanical - 5.7L) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Cylinder Boring and Honing >> Boring Procedure

Boring Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. A 0.25 mm (0.01 in) oversize service piston and piston ring set are available for the LS1/LS6 engine.

    Important:  Do not bore the cylinder liners on the LS1/LS6 engine.

  2. It is recommended to hone the cylinder to achieve proper fit for the oversize piston.

    Refer to the Cylinder Honing information for the proper honing procedure.

    Fig 1: View Of Cylinder Bore
    G01970826Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals