LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 652 (Suspension Control System - Suspension Damping) >> Repair Instructions >> Rear Position Sensor Replacement - Electronic Suspension >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the position sensor (3) in the vehicle.
    Fig 1: Installing Rear Position Sensor
    G01419595Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the position sensor mounting bolts (4).

    Tighten 

    Tighten the bolts to 7 N.m (62 lb in).

  3. Install the position sensor link to the control arm link stud (1).
  4. Connect the position sensor connector (2).
  5. Secure the position sensor harness with the retainers.
  6. Install the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals