LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 646 (Steering Wheel And Steering Column) >> Repair Instructions >> Telescope Motor Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to SIR CAUTION .
  1. Disable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
  2. Remove the steering column. Refer to STEERING COLUMN REPLACEMENT  .
  3. Secure the steering column to J 41352. 
  4. Insert J 42640  into the bottom of the lower trim cover.
  5. Disconnect the cable assembly (2) from the telescope drive motor assembly (1).
    Fig 1: Disconnecting Cable Assembly From Telescope Drive Motor Assembly
    G01419255Courtesy of GENERAL MOTORS CORP.
  6. Remove the connector clip (1) from the telescope drive motor assembly connector (2).
    Fig 2: Locating Telescope Drive Bracket Components
    G01419256Courtesy of GENERAL MOTORS CORP.
  7. Remove the 2 pan head tapping screws (4) from the telescope drive bracket (5).
  8. Remove the telescope drive motor assembly (2) from the telescope drive bracket (5).
  9. Remove the pan head tapping screw (3) from the telescope drive bracket (5).
  10. Remove the telescope drive bracket (5) from the jacket assembly.
scientia non olet · About LEMON Manuals