LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 642 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Heater Hose Replacement - Inlet >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the coolant. Refer to DRAINING AND FILLING COOLING SYSTEM in Engine Cooling.
    Fig 1: Removing Heater Hose Inlet
    G01418681Courtesy of GENERAL MOTORS CORP.
  2. Remove the retaining strap (1), which retains the heater inlet hose (2) to the evaporator tube - front.
    Fig 2: Removing Retaining Strap Which Retains Heater Inlet Hose To Evaporator Tube - Front
    G01418682Courtesy of GENERAL MOTORS CORP.
  3. Using the J 38185  , release and reposition the inlet heater hose clamp away from the heater pipe.
  4. Separate the inlet heater hose from heater pipe.
  5. Using the J 38185  , release and reposition the inlet heater hose clamp away from the engine coolant pump.
  6. Separate the heater inlet hose from coolant pump.
  7. Remove the inlet heater hose from the vehicle.
Fig 3: Separating Inlet Heater Hose From Heater Pipe
G01418683Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals