Installation Procedure
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Install the heater door.
- Install a new case seal
- Align and attach the HVAC case halves.NOTE: Refer to FASTENER NOTICE .
- Install the HVAC case retaining screws.
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
- Install the heater door linkage.
- Install the defroster actuator.
- Install the HVAC module. Refer to HVAC MODULE ASSEMBLY REPLACEMENT .