LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 642 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Clutch Rotor and/or Bearing Removal (V7 - Direct Mount) >> Tools Required

Tools Required

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the A/C compressor from the vehicle.
  2. Clamp J 41790  in a vise and attach the A/C compressor to J 41790  .
    Fig 1: Attaching A/C Compressor To J 41790
    G01418498Courtesy of GENERAL MOTORS CORP.
  3. Remove the clutch plate and hub assembly. Refer to COMPRESSOR CLUTCH PLATE AND HUB ASSEMBLY REMOVAL (V7 - DIRECT MOUNT)  .
  4. Using external snap ring pliers (1), remove the retaining ring (3) from the clutch rotor and bearing assembly.
    Fig 2: Removing Retaining Ring From Clutch Rotor And Bearing Assembly
    G01418499Courtesy of GENERAL MOTORS CORP.
  5. Place J 33023-A  on the clutch rotor.
    Fig 3: Placing J 33023 On Clutch Rotor
    G01418500Courtesy of GENERAL MOTORS CORP.
  6. Install J 41552  down into the inner circle of slots in the rotor. Turn J 41552  clockwise in the slots to engage the puller tangs with the rotor.
  7. Hold J 41552  in place and use a wrench to turn the center forcing screw against J 33023-A  to remove the clutch rotor and bearing assembly.
    Fig 4: Removing Clutch Rotor And Bearing Assembly
    G01418501Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals