LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 642 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the I/P lower insulator panel - RH. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT in Instrument Panel, Gages and Console.
    CAUTION: Unplug the blower motor before removal. Blower motor case contact with any ground may start the fan and cause personal Injury.
  2. Disconnect the blower motor electrical connector.
    Fig 1: Disconnecting Blower Motor Electrical Connector
    G01418699Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the blower motor cooling tube from the HVAC module.
  4. Remove the blower motor retaining screws.
  5. Remove the blower motor from the HVAC module.
    Fig 2: Removing Blower Motor From HVAC Module
    G01418700Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals