LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 642 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Blower Motor To HVAC Module
    G01418701Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor to the HVAC module.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the blower motor retaining screws.

    Tighten 

    Tighten the screws to 1.7 N.m (15 lb in).

  3. Connect the blower motor cooling tube to the HVAC module.
  4. Connect the blower motor electrical connector.
    Fig 2: Connecting Blower Motor Electrical Connector
    G01418702Courtesy of GENERAL MOTORS CORP.
  5. Install the I/P lower insulator panel - RH. Refer to CLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHT in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals