LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 624 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Heater Hose Replacement - Inlet (LY7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the inlet heater hose.
    2. Fig 1: Locating Heater Hoses
    GM819323Courtesy of GENERAL MOTORS CORP.
  2. Connect the inlet heater hose to the heater core.
  3. Using J 38185  connect the heater hose clamp.
  4. Connect the inlet heater hose to the inlet pipe.
  5. Connect the vacuum hose to the brake booster.
  6. Install the wiper motor module assembly. Refer to Wiper Motor Module Replacement in Wipers/Washer Systems.
  7. Fill the cooling system. Refer to Draining and Filling Cooling System in Engine Cooling.
scientia non olet · About LEMON Manuals