LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 624 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Blower Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Blower Motor
    GM295331Courtesy of GENERAL MOTORS CORP.
  1. Install the blower motor to the HVAC module assembly.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the blower motor mounting screws.

    Tighten:  Tighten the screws to 1.8 N.m (16 lb in).

    3. Fig 2: Blower Motor & Electrical Connector
    GM295327Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the blower motor.
  4. Install the right side instrument panel insulator. Refer to Closeout/Insulator Panel Replacement - Right in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals