Luggage Carrier New Installation
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the screws from the roof rail moldings.
- Remove the roof rail moldings from the roof.
- Position the luggage carrier side rails to the roof.
- Install the luggage carrier side rail screws to the side rails.
Tighten: Tighten the luggage carrier side rail screws to 6 N.m (53 lb in).
- Remove the luggage carrier side rail trim covers from the rails using a small flat bladed tool.
- Lift up on the luggage carrier cross rail levers in order to engage the cross rails into the side rails.
- Slide the luggage carrier cross rails to the desired position.
- Release the levers on the luggage carrier cross rails to lock them into position.
- Install the luggage carrier side rail trim covers to the slots in the rails, pressing until fully seated.
NOTE:
Refer to Fastener Notice in Cautions and Notices.