LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 613 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Transmission Vent Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air inlet duct. Refer to the appropriate service information.
  2. Use a hammer and a chisel in order to raise the transaxle vent seat off of the transaxle (37).
  3. Fig 1: View Of Transaxle Vent
    GM164785Courtesy of GENERAL MOTORS CORP.
  4. Use a flat-bladed tool in order to pry the transaxle vent out of the transaxle (37).