LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 613 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Automatic Transmission Range Selector Cable Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the throttle body air inlet duct. Refer to Air Cleaner Assembly Replacement in Engine Controls-3.4L.
    2. Fig 1: Identifying Automatic Transaxle Range Selector Cable To Cable Bracket
    GM629687Courtesy of GENERAL MOTORS CORP.
  2. Remove the automatic transaxle range selector lever cable from the automatic transaxle range selector lever.
    3. Fig 2: Identifying Automatic Transaxle Range Selector Lever Retaining Nut
    GM629693Courtesy of GENERAL MOTORS CORP.
  3. Remove the automatic transaxle range selector lever retaining nut.
  4. Remove the automatic transaxle range selector lever from the automatic transaxle.
scientia non olet · About LEMON Manuals