LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 610 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Center Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Rear Seat Center Belt Retractor
    GM620821Courtesy of GENERAL MOTORS CORP.
  1. Install the rear seat belt center retractor to the rear roof rail panel.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: View Of Rear Seat Belt Center Retractor Bolt
    GM620819Courtesy of GENERAL MOTORS CORP.
  2. Install the bolt to the rear seat belt center retractor.

    Tighten:  Tighten the rear seat belt center retractor bolt to 35 N.m (26 lb ft).

    3. Fig 3: Identifying Rear Upper Garnish Molding
    GM620962Courtesy of GENERAL MOTORS CORP.
  3. Install the rear upper garnish molding. Refer to Garnish Molding Replacement - Rear Upper .
    4. Fig 4: View Of Rear Seat Belt Buckle
    GM629069Courtesy of GENERAL MOTORS CORP.
  4. Install the rear seat belt center latch to buckle.
scientia non olet · About LEMON Manuals