LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 610 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - Right Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Seat Belt Buckle
    GM626938Courtesy of GENERAL MOTORS CORP.
  1. Install the seat belt buckle to the right front seat.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: View Of Seat Belt Buckle Anchor Stud Retaining Nut
    GM626937Courtesy of GENERAL MOTORS CORP.
  2. Install the nut to the seat belt anchor stud.

    Tighten:  Tighten the seat belt buckle anchor nut to 42 N.m (31 lb ft).

  3. Install the front seat cushion inner trim panel. Refer to Seat Cushion Inner Trim Panel Replacement - Front in Seats.
  4. Install the right front seat. Refer to Seat Replacement - Bucket in Seats.
scientia non olet · About LEMON Manuals