LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 610 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - Rear (Split Bench) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Seat Belt Buckle
    GM629069Courtesy of GENERAL MOTORS CORP.
  1. Install the rear seat belt buckle to the right and/or left rear seat belt anchor pulling the seat belt buckle through the slot in the rear seat cushion.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: Identifying Rear Bench Seat Belt Buckle Anchor Bolt
    GM629158Courtesy of GENERAL MOTORS CORP.
  2. Install the bolt to the right and/or left rear bench seat belt buckle anchor.

    Tighten:  Tighten the right and/or left rear seat belt buckle anchor bolt to 42 N.m (31 lb ft).

  3. Install the rear bench seat trim.
  4. Install the right and/or left rear split bench seat to the vehicle. Refer to Seat Replacement - Rear 50-50 Split in Seats.
scientia non olet · About LEMON Manuals