LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 610 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - No. 2 Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Bolts That Hold The Seat Belt Buckle To The Floor
    GM785529Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Position the seat belt buckle to the floor. Secure the buckle with the anchor bolt.

    Tighten:  Tighten the bolt to 53 N.m (30 lb ft).

  2. Install the rear storage compartment. Refer to Storage Compartment Replacement - Rear (Rendezvous) in Interior Trim.
  3. Close the lift gate.
scientia non olet · About LEMON Manuals