LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 610 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - Left Front >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Seat Belt Buckle
    GM626938Courtesy of GENERAL MOTORS CORP.
  1. Install the seat belt buckle to the left front seat.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: View Of Seat Belt Buckle Anchor Stud Retaining Nut
    GM626937Courtesy of GENERAL MOTORS CORP.
  2. Install the nut to the seat belt anchor stud.

    Tighten:  Tighten the seat belt buckle anchor nut to 42 N.m (31 lb ft).

    3. Fig 3: Identifying Seat Belt Buckle Electrical Connector
    GM626940Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connector to the seat belt buckle.
  4. Install the front seat cushion inner trim panel. Refer to Seat Cushion Inner Trim Panel Replacement - Front in Seats.
  5. Install the left front seat. Refer to Seat Replacement - Bucket in Seats.
scientia non olet · About LEMON Manuals