Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Master Cylinder Reservoir Components

Courtesy of GENERAL MOTORS CORP.

Lubricate the new O-rings and the reservoir-to-housing fittings. Use clean brake fluid.
Insert the O-rings (4) into the grooves in the reservoir. Ensure that the O-rings are properly seated.
Install the reservoir (3) to the master cylinder body. Use your hand in order to push the reservoir straight down into the body.

Fig 2: Removing/Installing Reservoir Retaining Pins

Courtesy of GENERAL MOTORS CORP.

Install the spring pins in order to retain the reservoir. Do not damage the reservoir or the cylinder body.
Install the master cylinder. Refer to Master Cylinder Replacement .