LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 608 (Hydraulic Brake System) >> Repair Instructions >> Brake Hose Replacement - Rear (Disc Brake) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rubber plug from the brake caliper.
    2. Fig 1: Identifying Brake Hose & Components
    GM176035Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Install NEW copper brake hose gaskets (3).
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Assemble the brake hose bolt and the NEW copper brake hose gaskets to the brake hose (2).
  3. Install the brake hose bolt to the brake caliper (1).

    Tighten:  Tighten the brake hose bolt to 43 N.m (32 lb ft).

    NOTE: Make sure the brake hose is not twisted or kinked after installation. Damage to the hose could result.
    IMPORTANT: Use the stripe on the brake hose in order to align the brake hose with the notch in the brake hose bracket.
    4. Fig 2: Identifying Brake Hose Retainer
    GM629382Courtesy of GENERAL MOTORS CORP.
  4. Install the brake hose (3) to the brake hose bracket (2).
  5. Install the brake hose retainer (4) to the brake hose (3).
  6. Remove the rubber cap or plug from the exposed brake pipe fitting end.
  7. Install the brake pipe fitting (1) to the brake hose.

    Tighten:  Tighten the brake pipe fitting to 21 N.m (15 lb ft).

  8. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  9. Install the wheel and tire. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals