LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 607 (Engine Mechanical (Repair Instructions 2 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 2 & Off-Vehicle Part 1) >> On-Vehicle Repair Instructions - Part 2 >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
    2. Fig 1: Identifying Oil Pressure Sensor Electrical Connector
    GM1394025Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the oil pressure sensor electrical connector.
    3. Fig 2: Engine Oil Pressure Sensor
    GM1401653Courtesy of GENERAL MOTORS CORP.
  3. Remove the oil pressure sensor.
scientia non olet · About LEMON Manuals